To send a message simply fill out the form below.
Enquiry from Online Galleries regarding "Industrial clock based on a steam hammer"
|If you do NOT want to receive newsletters from us regarding the antiques trade, please UNCHECK this box.|
To send this page to a friend, fill out the form below..
Look at what I found on the Online Galleries website!
It is based on a steam pump with the boiler below flanked by the furnaces to either side. Rising up from the boiler is a connecting rod which rotates the large fly-wheel and also the governor consisting of two balls suspended by pivoted steel rods. In the original, as the speed of rotation increases the balls are thrown outwards, which in turn regulates the speed at which the fly-wheel rotates. On this model a lever on the right may be used to lock the fly-wheel. On its release the wheel, with maybe a little touch, depending on the state- of- wind, starts rotating and, if fully wound, will continue to do so for around two hours.
A timepiece is mounted above the furnace on the left. The gilded centre of the dial bears Chinese writing which would indicate that this piece was exported to that country. The silvered chapter ring has roman numerals. To the right is an anaeroid barometer calibrated 27-31 and inscribed stormy, rain, change, fair and very dry with presumably the Chinese equivalents beneath them
The whole rests on a rouge-marble base with heavy shaped and gilded block feet. Above is a diamond patterned silvered platform. The brick fronts of the furnaces are finished in copper with grey steel coloured fluted columns to either side. Six similarly finished fluted corinthian columns rise up from this to an upper platform on which the governor and silver blue fly-wheel rests.
Height:- 18.3" (46.5cms)
Width:- 14". ( 36cms.)
For a detailed account of Guilmet and the Industrial clocks see:-
Mystery, Novelty and Fantasy Clocks by Derek Roberts. Chapters 21 & 22. Schiffer, Atglen, USA.
|Height||46.00 cm||(18.11 inches)|
|Width||36.00 cm||(14.17 inches)|